Mounting with the universal adapter (screwed)¶
This guide applies to the WattWächter Gas – Magnetic Field (GW-MF) on diaphragm gas meters made by Pietro Fiorentini, e.g. RS/2001 or RS/2.0 — also when they are installed under the names SamGas or Heitland. You can recognise them by a pocket below the window with a lug with a hole underneath. The dial reads "1 imp ≙ 0.01 m³".
For other meters see Meter preparation.
What you need¶
- WattWächter Gas – Magnetic Field
- Universal adapter — on Pietro Fiorentini meters it is screwed on
- Screw (M5) and nut
- Phillips screwdriver
The universal adapter, screw and nut come with the WattWächter Gas – Magnetic Field. You do not need to open anything on the meter. The green seals on the register stay untouched.
Guide for printing
The same steps are available as an illustrated guide without text for printing: Mounting guide as PDF.
Step by step¶
-
Insert the adapter. Bring the universal adapter up to the meter from the front: the ring goes into the pocket below the window, with its opening facing up. The two notches in the plate hook into the outer wall of the pocket, and the plate rests on the lug. The holes in plate and lug then line up.
-
Screw the adapter on. Push the screw through plate and lug from the front and turn the nut on at the back. Hold the nut with your fingers and tighten the screw hand-tight — not too tight, the lug is made of plastic.
-
Push the sensor in. Push the sensor, sensor head first, into the ring from the front until it sits firmly. It then sticks out horizontally from the meter.
-
Connect the USB-C cable. The sensor now sits in the pocket below the register.
Do not rotate the sensor once the meter reading is entered
The sensor can be rotated in the ring — that is normal. Once you have entered the meter reading, do not rotate it any more — otherwise the reading is off afterwards and you have to correct it.
Check whether the sensor sits correctly during setup in step 6.