Skip to content

Frequently asked questions (FAQ)

Which meters can I read with the WattWächter TTL?

In principle all meters with an optical interface (infrared, D0). The TTL is a pure reading head; which data you get depends on your software. Most modern meters send SML on their own, older meters speak IEC 62056-21 and have to be requested. There is a Python example for both cases. The meters we know are listed under Supported meters.

Do I need the white TX wire?

Only if your meter has to be asked to send — this mainly applies to older meters with the IEC 62056-21 protocol. Meters that send SML on their own are read via the green RX wire alone. On the older TTL with a fixed cable, the TX wire is yellow. Which meters need a request is shown by footnote ⁴ under Supported meters.

Do I have to cross RX and TX?

No. The wires are connected 1:1 (RX to RX, TX to TX); the crossover is already inside the reading head — see Connection → Wiring.

Does the TTL work with 3.3 V and with 5 V?

Yes. The WattWächter TTL operates at 3–5 V. Its data line carries the level of the supply: power it with 3.3 V on 3.3 V boards (ESP32, ESP8266, Raspberry Pi) and with 5 V on 5 V boards, then no level shifter is needed. Powered with 5 V, it also outputs 5 V on RX, which an ESP32 or Raspberry Pi cannot tolerate. A built-in reverse polarity protection guards it against incorrect wiring.

Which baud rate does the meter use?

SML meters usually send at 9600 baud, 8N1. Meters with the IEC 62056-21 protocol start at 300 baud, 7E1 and, after the request, switch to the baud rate given in their identification — Python script 2 does this automatically.

Why do I only get meter readings but no power?

Many meters only release the instantaneous values after unlocking with the PIN from your grid operator. Disable the PIN prompt on the meter and set Inf to On — see Meter preparation.

Can I connect the TTL to the WattWächter Tasmota?

Only to the Gen.1: it can read up to two more WattWächter TTL (cascading, Wi-Fi mode only). The Gen.2 no longer supports the TTL — see WattWächter Tasmota.

How do I get the values into Home Assistant?

The easiest way is an ESP32 with ESPHome — see ESPHome.

Can I connect the TTL to a PC or Mac with a USB-C cable?

No. The USB-C socket on the head carries TTL signals, not USB. On a PC, Mac or charger the head does not work, but nothing gets damaged either. For a direct USB connection there is the WattWächter USB: same housing, but with a built-in USB converter.

If you still want to test the TTL on a PC, use a standard USB-to-TTL adapter (e.g. CP2102, FT232, CH340): plug the wires 1:1 onto the adapter's RXD, TXD, 3V3 and GND. The scripts are under Python.

How do I tell which version of the TTL I have?

The current TTL has a USB-C socket and a pluggable cable with red, green, white and black wires. The older TTL has a permanently attached cable with brown, green, yellow and white wires and a 3D-printed housing, see Older version.