Older version (fixed cable)¶
This page applies to the older WattWächter TTL with a permanently attached cable and a 3D-printed housing. The current TTL has a USB-C socket and a pluggable cable with different wire colors instead, see WattWächter TTL.
The guides under Connection, ESPHome, Raspberry Pi, Arduino and Python apply to both versions. Only the wire colors differ, see below.
Wire colors¶
| Wire color | Function on the TTL | Current TTL |
|---|---|---|
| Brown | VCC (3–5 V) | Red |
| Green | RXD (data receive) | Green |
| Yellow | TXD (data transmit) — optional | White |
| White | GND | Black |
The pins per board are the same as for the current TTL, see Connection → Pins per board. Where it says "white" for the TX wire there, use the yellow wire on the older head. Use brown instead of red and white instead of black.
Inside the housing, the wires sit on a 4-pin screw terminal.
Technical specifications¶
| Property | Specification |
|---|---|
| Dimensions (D × H) | Ø32 mm × 21 mm |
| Weight | 25 g |
| Magnetic holding force | approx. 8.5 kg |
| Housing material | PLA |
| Data transfer | TTL RX / TX |
| Power supply | DC 3.3–5 V |
| Connection | 4 wires with Dupont connectors; inside the housing on a 4-pin screw terminal |
| Cable length | approx. 1 m (pre-installed) |
| Power consumption | < 0.5 W |
| Operating temperature | 10 °C – 50 °C |
| IR LED wavelength | 850 nm |
| Photo sensitivity | 880–1120 nm |
