LED & button¶
The WattWächter Plus shows its state with two RGB LEDs and has a function button.
LED Status Indicator¶
The RGB LED shows the current device status. The WattWächter Plus has two RGB LEDs that always show the same colour.
When several states are active at the same time, the LED shows the one with the highest priority. From high to low: factory reset, Bluetooth, firmware update, critical error, meter waiting for input, warning, start-up, normal operation. So while Bluetooth mode is running, you will see neither yellow nor red.
What you can do for each colour is described under Troubleshooting.
| Status | Color | Mode | Meaning |
|---|---|---|---|
| Normal operation | Green | Solid, dimmed | Everything OK |
| Start-up | Green | Pulsing | The device is starting |
| Warning | Yellow | Pulsing | No Wi-Fi connection: connecting failed or the connection was lost |
| Meter waiting for input | Yellow | Pulsing | Meter password missing or rejected (NES/Echelon only) |
| Critical error | Red | Pulsing | Meter not responding or firmware update failed |
| Firmware update | Magenta | Solid | OTA update in progress |
| BLE pairing mode | Blue | Pulsing | Bluetooth waiting for a connection; switches off after 15 minutes without a connection |
| BLE connected | Blue | Solid | Bluetooth device connected |
| Factory reset | Red | Solid | Function button is being held; the factory reset follows after 7 seconds |
Disable LED
The LED can be turned off entirely — see Settings → Status LED. It still shows critical error (red, pulsing) and factory reset (red, solid).
Function Button¶
The WattWächter has a function button that can be used to trigger various actions. The button can be pressed with a thin object such as a SIM ejector tool, a toothpick, or an unfolded paper clip.
The button sits top left above the WattWächter logo.
Activate BLE mode and access point (short press)¶
A short press (less than 2 seconds) on the button activates Bluetooth mode (BLE) and the device's access point. The LED starts pulsing blue, indicating that the device is ready to be paired via the app. Through the access point you reach the web interface at http://192.168.4.1, even if the device is not on your Wi-Fi.
This is useful when:
- You want to connect another smartphone to the WattWächter
- You need to repeat the initial setup
- You want to change WiFi settings via the app
BLE mode switches off after 15 minutes without a connection. The access point switches off after 15 minutes if nobody connects to it.
Save Data (short press)¶
A short press also saves the current measurement data from the RAM buffer permanently to internal storage.
Before Disconnecting Power
The WattWächter buffers measurement data in RAM and periodically writes it to storage. If you disconnect the device from power without pressing the button first, you may lose up to 6 hours of measurement data in the worst case.
Recommendation: Press the function button briefly before unplugging and wait until the LED pulses blue — the data is then saved.
Factory Reset (long press > 7 seconds)¶
Holding the function button for at least 7 seconds triggers a factory reset. How it works in detail and what it deletes is described on the Factory reset page.
Overview¶
| Action | Duration | Function |
|---|---|---|
| Short press | < 2 seconds | Activate BLE and access point, save data |
| Long press | from 2 seconds | LED red: warning, releasing cancels |
| Long press | ≥ 7 seconds | Factory reset |


